Need help to figure out what I am doing wrong. The first picture shows my Multisim circuit. I set the VP to 1 and change the frequency as shown in the table

Need help to figure out what I am doing wrong. The first picture shows my Multisim circuit. I set the VP to 1 and

change the frequency as shown in the table. I measured the Vout P-P. I then used 20 log(Vout / Vin) to get the dB. All these are shown in the table on the picture. My problem is that the very next page of the instructions ask me to do a graph of the frequency response of the filter. As shown in the second picture, the dB’s start at -12 and ascend to 0. My calculations in the table go from -7.89 dB up to 11.91 dB. Something is not right. Should I not have gotten any dB measurements above 0? And if that is the case, what did I do wrong in my calculations?

Background image of page 1

Save your time - order a paper!

Get your paper written from scratch within the tight deadline. Our service is a reliable solution to all your troubles. Place an order on any task and we will take care of it. You won’t have to worry about the quality and deadlines

Order Paper Now